• 19 Independent adjustable parameters (via on-board controls panel) allow fine-tuning of settings in-field, with LED feedback display

  • Low Current Output Terminals for low current range requirements

  • Can be driven with any source capable of 2.5V Neutral, 4V full-forward, and 1V full-reverse (PQ Joystick Electrical Option 58)

  • PWM Outputs with thermal type current limit, high current SMARTFET capable of 2.5 amps

  • 3 Auxiliary outputs for out-of-neutral indication, directional valves, blocking valves, back-up alarms, brake-release, etc.

  • Regulated coil output current compensates for coil resistance changes due to temperature variations

  • Rugged potted assembly seals electronics from environment and prevents failures due to moisture ingression, shock, or mechanical damage

  • CE Compliance allows customers to sell into the European Community


  • Electrical

    Supply Voltage 10-30 VDC
    PWM Outputs (A, B) Configurable from 10 - 2500mA
    Regulated Output Current Fixed within 2%
    Auxiliary Outputs (A, B, Common*) 2.5 amps
    Protection Reverse Polarity, Over-Voltage, Open/Shorted Signal Leads, EMI/RFI Hardened, Transient Voltage Supply
    Regulated Power Out (PT+, PT-) 5 VDC (may be used to power 5V command source)
    Signal Input 1 - 4 VDC, 2.5 Neutral (30% Signal Swing)

    Environmental

    Operating Temperature -40 - 85 degrees (C)
    Protection Sealed Epoxy Potting
    Resistance Humidity, Water/Rain, Sun/UV Exposure

    Adjustments / Features:

    Frequency 45 - 450 Hz
    Ramp (Time Delay) 0 - 5 Sec Up, 0 - 5 Sec Down
    Deadband 10 - 50%
    Auxiliary Ouputs 10 - 50% (A, B) 10 - 100% (Common)
    HI A, B (Full Flow Current) 10 - 2500 mA
    LO A, B (Threshold Current) 10 - 2500 mA
    MID A, B 10 - 2500 mA (defaults to 50% of full flow current)
    Creep for safe mode operation
    Typical Application: (1) M115 Joystick w/ Opt. 58 Electronics, (1) 519 Valve Drive Board